znrobotics 智能工场

You are viewing an older revision! See the latest version

SeeedArchLink

Table of Contents

  1. Robotics Workshop: using Temperature sensor to control Robotics Servo
  2. Setup

Robotics Workshop: using Temperature sensor to control Robotics Servo

Welcome to our session! If you have any questions, please ask us. We are here to help.

In this session we'll work through 4 examples together. We will demonstrate everything, but this document should help you in case you're stuck. We also have optional sections in case you want to go further.

If you happen to be much faster than everyone else, help your neighbors.

Setup

  1. Connect the Temperature sensor as well as the Servo to the Seeeduino-Arch-Link board, and then connect the board to you PC using the micro-USB cable.
  2. The board mounts as a mass-storage device (like a USB drive). Verify that you can see it (drive name will be MBED).
  3. Go to http://developer.mbed.org
  4. Create an ARM mbed account if you do not have one.
  5. On the top right corner, click the Compiler button.
All wikipages