znrobotics 智能工场 / Mbed 2 deprecated Seeed_Arch_link_TempAndHumidity

Read the temperature and humidity from the sensor and print them.

Dependencies:   DHT22 mbed

Fork of Program2_TempAndHumidity by Robotics Kit Workshop

You are viewing an older revision! See the latest version

Homepage

Table of Contents

  1. Seeed_Arch_link_Blinky
  2. Setup

Seeed_Arch_link_Blinky

Setup

  1. Connect the Temperature sensor as well as the Servo to the Seeeduino-Arch-Link board, and then connect the board to you PC using the micro-USB cable.
  2. The board mounts as a mass-storage device (like a USB drive). Verify that you can see it (drive name will be MBED).
  3. Go to http://developer.mbed.org
  4. Create an ARM mbed account if you do not have one.
  5. On the top right corner, click the Compiler button.

An IDE should open. Congratulations!

On Windows: To see debug messages, install the serial driver.

Debug messages: We can talk to the board via a serial port, but you might need some software. Read this doc and install required software (like PuTTY or CoolTermon Windows).

Locally: If you like things locally, you can do so by exporting to a supported toolchain.

I very much recommend to just use the online IDE, as it makes it easier for us, but if you want to continue hacking in the future, this is a nice way.

All wikipages