File content as of revision 6:f2c29bab3feb:

/* mbed Example Program
 * Copyright (c) 2006-2015 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */

#include "mbed.h"

// Initialize a pins to perform analog and digital output fucntions
AnalogOut  aout(A5);
DigitalOut dout(LED1);

int main(void)
{
    while (1) {
        // change the voltage on the digital output pin by 0.1 * VCC
        //  and print what the measured voltage should be (assuming VCC = 3.3v)
        for (float i = 0.0f; i < 1.0f; i += 0.1f) {
            aout = i;
            printf("aout = %1.2f volts\n", aout.read() * 3.3f);
            // turn on the led if the voltage is greater than 0.5f * VCC
            dout = (aout > 0.5f) ? 1 : 0;
            wait(1.0f);
        }
    }
}