mbed-os-examples / Mbed OS mbed-os-example-client

This is a simple mbed client example demonstrating, registration of a device with mbed Device Connector and reading and writing values as well as deregistering on different Network Interfaces including Ethernet, WiFi, 6LoWPAN ND and Thread respectively.

You are viewing an older revision! See the latest version

Homepage

Table of Contents

  1. Getting started with mbed Client on mbed OS
  2. Required hardware
  3. Further instructions

Getting started with mbed Client on mbed OS

This is the mbed Client example for mbed OS. It demonstrates how to register a device with mbed Device Connector, how to read and write values, and how to deregister. If you are unfamiliar with mbed Device Connector, we recommend that you read the introduction to the data model first.

The application:

  • Connects to network with WiFi, Ethernet, 6LoWPAN ND or Thread connection.
  • Registers with mbed Device Connector.
  • Gives mbed Device Connector access to its resources (read and write).
  • Records the number of clicks on the device’s button and sends the number to mbed Device Connector.
  • Lets you control the blink pattern of the LED on the device (through mbed Device Connector).

Required hardware

  • K64F board.
  • 1-2 micro-USB cables.
  • mbed 6LoWPAN gateway router for 6LoWPAN ND and Thread.
  • mbed 6LoWPAN shield (AT86RF212B/AT86RF233 for 6LoWPAN ND and Thread.
  • Ethernet cable and connection to the internet.

Further instructions

To continue, please follow the instructions available here

All wikipages