ST Americas mbed Team
ACKme WiFi module + Nucleo MEMS module example. Connect and publish sensor data to M2X.
Dependencies: M2XStreamClient WiConnect Nucleo_Sensor_Shield jsonlite mbed
Fork of
m2x-MEMS_ACKme_Wifi_demo
by 
David Kwak
You are viewing an older revision! See the latest version
Adding Sensors and Cloud Connectivity
ACKme WiFi Shield, Nucleo Sensors, and M2X Demo¶
This example demonstrates how to use the ACKme WiFi shield to upload data obtained from ST's Nucleo sensors shield to the cloud (M2X) with the STM32F411 Nucleo board:
First, attach the ACKme WiFi shield to the Nucleo board as shown here:
Next, attach the sensor shield to the WiFi shield as shown here:
These two shields must be connected in this order as they will not fit in the opposite order.
Next, connect the STM32F411 Nucleo board to your PC with a USB cable.
The mbed page for the ACKme WiConnect Host Library is found here:
Import libraryWiConnect
Host library for controlling a WiConnect enabled Wi-Fi module.
Last commit 28 Sep 2015 by 
ACKme
The mbed page for the AT&T M2X Stream Client Library is found here:
Import libraryM2XStreamClient
ARM mbed M2X API Client: The ARM mbed client library is used to send/receive data to/from AT&T's M2X service from mbed LPC1768 microcontrollers.
Last commit 15 Jun 2016 by 
AT&T M2X Team
Now return to the m2x-MEMS_ACKme_Wifi_demo project homepage and import the project into your mbed compiler:
Click “Import” button on the pop up window shown below
Enter the SSID name and password of your local WiFi hotspot in the #define NETWORK_SSID and #define NETWORK_PASSWORD
Compile and load the image onto the F411 Nucleo board
Note
Refer to Getting Started with mbed and the STM32F411 Nucleo Board to learn how to compile and load a program onto the Nucleo board
Open a terminal window to display the status of your program. For this example, make sure that Receive is set to LF and transmit is set to CR, and set the terminal BAUD rate to 9600
Note
Refer to Creating Console Output for setting a terminal emulator