mbed-src updated for BMD-200 evaluation board. Just pin numbers are updated.

Dependents:   mbed_blinky-bmd-200 bmd-200_accel_demo firstRig

Fork of mbed-src by mbed official

Replacement for the "mbed" or "mbed-src" library when using the BMD-200 Evaluation kit. This library only remaps the pin names (i.e. LED1 points to p0.01 instead of p0.18, etc) as used by the BMD-200 Evaluation board (select the nRF51822_mkit platform). All other code is untouched.

common/gpio.c

Committer:
dcnichols
Date:
2015-07-10
Revision:
592:5e2eb8beba71
Parent:
221:8276e3a4886f

File content as of revision 592:5e2eb8beba71:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "gpio_api.h"

static inline void _gpio_init_in(gpio_t* gpio, PinName pin, PinMode mode)
{
    gpio_init(gpio, pin);
    if (pin != NC) {
        gpio_dir(gpio, PIN_INPUT);
        gpio_mode(gpio, mode);
    }
}

static inline void _gpio_init_out(gpio_t* gpio, PinName pin, PinMode mode, int value)
{
    gpio_init(gpio, pin);
    if (pin != NC) {
        gpio_write(gpio, value);
        gpio_dir(gpio, PIN_OUTPUT);
        gpio_mode(gpio, mode);
    }
}

void gpio_init_in(gpio_t* gpio, PinName pin) {
    gpio_init_in_ex(gpio, pin, PullDefault);
}

void gpio_init_in_ex(gpio_t* gpio, PinName pin, PinMode mode) {
    _gpio_init_in(gpio, pin, mode);
}

void gpio_init_out(gpio_t* gpio, PinName pin) {
    gpio_init_out_ex(gpio, pin, 0);
}

void gpio_init_out_ex(gpio_t* gpio, PinName pin, int value) {
    _gpio_init_out(gpio, pin, PullNone, value);
}

void gpio_init_inout(gpio_t* gpio, PinName pin, PinDirection direction, PinMode mode, int value) {
    if (direction == PIN_INPUT) {
        _gpio_init_in(gpio, pin, mode);
        if (pin != NC)
            gpio_write(gpio, value); // we prepare the value in case it is switched later
    } else {
        _gpio_init_out(gpio, pin, mode, value);
    }
}