Please use mbed-src instead of this library.mbed-src supports GR-PEACH rev.C. mbed-srcライブラリをご利用ください。mbed-srcはGR-PEACH rev.Cに対応しています。
Fork of mbed-src_GR-PEACH_rev_c by
common/board.c
- Committer:
- RyoheiHagimoto
- Date:
- 2015-04-06
- Revision:
- 491:affe2fb21f3a
- Parent:
- 228:85a676113daa
File content as of revision 491:affe2fb21f3a:
/* mbed Microcontroller Library * Copyright (c) 2006-2013 ARM Limited * * Licensed under the Apache License, Version 2.0 (the "License"); * you may not use this file except in compliance with the License. * You may obtain a copy of the License at * * http://www.apache.org/licenses/LICENSE-2.0 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ #include "gpio_api.h" #include "wait_api.h" #include "toolchain.h" #include "mbed_interface.h" WEAK void mbed_die(void) { #ifndef NRF51_H __disable_irq(); // dont allow interrupts to disturb the flash pattern #endif #if (DEVICE_ERROR_RED == 1) gpio_t led_red; gpio_init_out(&led_red, LED_RED); #elif (DEVICE_ERROR_PATTERN == 1) gpio_t led_1; gpio_init_out(&led_1, LED1); gpio_t led_2; gpio_init_out(&led_2, LED2); gpio_t led_3; gpio_init_out(&led_3, LED3); gpio_t led_4; gpio_init_out(&led_4, LED4); #endif while (1) { #if (DEVICE_ERROR_RED == 1) gpio_write(&led_red, 1); #elif (DEVICE_ERROR_PATTERN == 1) gpio_write(&led_1, 1); gpio_write(&led_2, 0); gpio_write(&led_3, 0); gpio_write(&led_4, 1); #endif wait_ms(150); #if (DEVICE_ERROR_RED == 1) gpio_write(&led_red, 0); #elif (DEVICE_ERROR_PATTERN == 1) gpio_write(&led_1, 0); gpio_write(&led_2, 1); gpio_write(&led_3, 1); gpio_write(&led_4, 0); #endif wait_ms(150); } }