File content as of revision 636:c140da0be6c8:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#ifndef MBED_SLEEP_API_H
#define MBED_SLEEP_API_H

#include "device.h"

#if DEVICE_SLEEP

#ifdef __cplusplus
extern "C" {
#endif

/** Send the microcontroller to sleep
 *
 * The processor is setup ready for sleep, and sent to sleep using __WFI(). In this mode, the
 * system clock to the core is stopped until a reset or an interrupt occurs. This eliminates
 * dynamic power used by the processor, memory systems and buses. The processor, peripheral and
 * memory state are maintained, and the peripherals continue to work and can generate interrupts.
 *
 * The processor can be woken up by any internal peripheral interrupt or external pin interrupt.
 *
 * @note
 *  The mbed interface semihosting is disconnected as part of going to sleep, and can not be restored.
 * Flash re-programming and the USB serial port will remain active, but the mbed program will no longer be
 * able to access the LocalFileSystem
 */
void sleep(void);

/** Send the microcontroller to deep sleep
 *
 * This processor is setup ready for deep sleep, and sent to sleep using __WFI(). This mode
 * has the same sleep features as sleep plus it powers down peripherals and clocks. All state
 * is still maintained.
 *
 * The processor can only be woken up by an external interrupt on a pin or a watchdog timer.
 *
 * @note
 *  The mbed interface semihosting is disconnected as part of going to sleep, and can not be restored.
 * Flash re-programming and the USB serial port will remain active, but the mbed program will no longer be
 * able to access the LocalFileSystem
 */
void deepsleep(void);

#ifdef __cplusplus
}
#endif

#endif

#endif