ublox_evk_nina_b1.c

00001 /**
00002  * @file    ublox_evk_nina_b1.c
00003  * @brief   board ID for the UBLOX_EVK_NINA_B1
00004  *
00005  * DAPLink Interface Firmware
00006  * Copyright (c) 2009-2019, ARM Limited, All Rights Reserved
00007  * SPDX-License-Identifier: Apache-2.0
00008  *
00009  * Licensed under the Apache License, Version 2.0 (the "License"); you may
00010  * not use this file except in compliance with the License.
00011  * You may obtain a copy of the License at
00012  *
00013  * http://www.apache.org/licenses/LICENSE-2.0
00014  *
00015  * Unless required by applicable law or agreed to in writing, software
00016  * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
00017  * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
00018  * See the License for the specific language governing permissions and
00019  * limitations under the License.
00020  */
00021 
00022 #include "DAP_config.h"
00023 #include "target_board.h"
00024 #include "target_family.h"
00025 
00026 static void nina_swd_set_target_reset(uint8_t asserted){
00027     if(!asserted) {
00028         PIOA->PIO_MDER = PIN_SWDIO | PIN_SWCLK | PIN_nRESET;
00029     }
00030 }
00031 
00032 const board_info_t g_board_info = {
00033     .info_version = kBoardInfoVersion,
00034     .board_id = "1237",
00035     .family_id = kNordic_Nrf52_FamilyID,
00036     .swd_set_target_reset = nina_swd_set_target_reset,
00037     .target_cfg = &target_device,
00038 };