target.c

00001 /**
00002  * @file    target.c
00003  * @brief   Target information for Realtek RTL8195AM
00004  *
00005  * DAPLink Interface Firmware
00006  * Copyright (c) 2016-2019, Realtek Semiconductor Corp., All Rights Reserved
00007  * SPDX-License-Identifier: Apache-2.0
00008  *
00009  * Licensed under the Apache License, Version 2.0 (the "License"); you may
00010  * not use this file except in compliance with the License.
00011  * You may obtain a copy of the License at
00012  *
00013  * http://www.apache.org/licenses/LICENSE-2.0
00014  *
00015  * Unless required by applicable law or agreed to in writing, software
00016  * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
00017  * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
00018  * See the License for the specific language governing permissions and
00019  * limitations under the License.
00020  */
00021 
00022 #include "target_config.h"
00023 
00024 // The file flash_blob.c must only be included in target.c
00025 #include "flash_blob.c"
00026 
00027 // target information
00028 target_cfg_t target_device = {
00029     .sectors_info                   = sectors_info,
00030     .sector_info_length             = (sizeof(sectors_info))/(sizeof(sector_info_t)),
00031     .flash_regions[0].start         = 0x00000000,
00032     .flash_regions[0].end           = 0x00000000 + MB(2),
00033     .flash_regions[0].flags         = kRegionIsDefault ,
00034     .flash_regions[0].flash_algo    = (program_target_t *) &flash,    
00035     .ram_regions[0].start           = 0x10007000,
00036     .ram_regions[0].end             = 0x10070000,
00037 };
00038 
00039 // RTL8195AM's main cpu can only talk 38400 with DAP UART
00040 #include "uart.h"
00041 static UART_Configuration UART_Config;
00042 
00043 int32_t USBD_CDC_ACM_SetLineCoding(void)
00044 {
00045     UART_Config.Baudrate    = 38400;
00046     UART_Config.DataBits    = UART_DATA_BITS_8;
00047     UART_Config.Parity      = UART_PARITY_NONE;
00048     UART_Config.StopBits    = UART_STOP_BITS_1;
00049     UART_Config.FlowControl = UART_FLOW_CONTROL_NONE;
00050 
00051     return uart_set_configuration(&UART_Config);
00052 }