Revision 0:c98fab4c30c9, committed 2016-01-13

Comitter:

thesteira

Date:

Wed Jan 13 16:42:10 2016 +0000

Commit message:

Ultraschall Test

Changed in this revision

diff -r 000000000000 -r c98fab4c30c9 main.cpp
--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/main.cpp	Wed Jan 13 16:42:10 2016 +0000
@@ -0,0 +1,41 @@
+#include "mbed.h"
+ 
+// MaxSonar EZ1 test program
+// by Michael Shimniok http://www.bot-thoughts.com/
+//
+// Based on datasheet here: http://www.maxbotix.com/uploads/LV-MaxSonar-EZ1-Datasheet.pdf
+// Reads from AN (analog) pin connected to mbed p20, assumes 3.3V supply to EZ1 module.
+//
+// mbed -> EZ1
+// -----------
+// VOUT -> +5
+// GND  -> GND
+// p20  -> AN
+//
+ 
+AnalogIn ain(p20);
+Serial pc(USBTX, USBRX); // tx, rx
+ 
+int main() {
+    float adc, volts, inches;
+    int feet, in;
+    float inch;
+    float cm;
+    pc.baud(115200);
+    
+    while (1){
+        adc = ain.read();           // read analog as a float
+        volts = adc * 3.3;          // convert to volts
+        //inches = volts / 0.0064;    // 3.3V supply: 6.4mV per inch
+        inches = volts / 0.0098;    // 5V supply: 9.8mV per inch
+        feet = (int) inches / 12;   // inches to feet (trunc)
+        in = (int) inches % 12;     // remainder -> in(ches)
+        cm=in*2.54;
+        pc.printf("%8.2f adc %8.2fV %8.2f in %d'%d\   %8.2fcm ""\n", adc, volts, inches, feet, in,cm);
+        //pc.printf("%8.2f cm""\r",cm);
+ 
+        //wait(0.05);
+        wait(0.5);                 // 20Hz update rate ; note we aren't truly synchronized to the device or anything...   
+    }
+}
+ 
\ No newline at end of file

diff -r 000000000000 -r c98fab4c30c9 mbed.bld
--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/mbed.bld	Wed Jan 13 16:42:10 2016 +0000
@@ -0,0 +1,1 @@
+http://mbed.org/users/mbed_official/code/mbed/builds/9296ab0bfc11
\ No newline at end of file