Francesco Filipazzi

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

8 years, 3 months ago.

St Nucleo does not work anymore

Hello i used the ST Nucleo Board stm32 F401 (with the WIFI Module and the motion MEMS environmental) two days ago for the last time, and all was ok. Now the board doesn't work anymore. I tried to load the example code of the blinking led, but it doesn't work too. On the Nucleo Board : The Led "LD1" is green, the "LD3" is red On WIFI board: LED1 is green, LED4 is orange.

Thank you

1 Answer

Andrea Corrado
8 years, 3 months ago.

Hi francesco,

Sorry for the issues,

Have you looked at downloading ST LINK Utility: http://www.st.com/en/embedded-software/stsw-link004.html

And then either erasing the target flash, or updating the STlink?

Regards,

Andrea, team mbed

Accepted Answer

Thank you, i updated the firmware and the board started to work. It's very strange but it's ok :-)

posted by Francesco Filipazzi 09 May 2017