Karolis Misiunas

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

8 years, 2 months ago.

After firmware update mbed does not start anymore

Just attempter to update OM13071: LPCXpresso824-MAX following these instructions:

https://developer.mbed.org/handbook/Firmware-LPCXpresso824-MAX

However, after update the board always boots into "CRP DISABLD" mode. I can't seem to force it into "mbed" mode anymore.

has anyone seen this before?

Question relating to:

Last updated: 31 Mar 2019
LPCXpresso824-MAX from NXP is an mbed enabled platform which combines the advantages of the mbed ecosystem and Arduino form factor.

1 Answer

Toyomasa Watarai
8 years ago.

Can you try the latest DAPLink firmware in this zip file? https://github.com/mbedmicro/DAPLink/releases/download/0242/0242_release_package_eab079b8.zip

Filename: 0242_lpc11u35_lpc824xpresso_0x0000.bin

Accepted Answer

Works! Though there was an issue where macOS complained about drive not containing enough space

```mv: /Volumes/CRP DISABLD/0242_lpc11u35_lpc824xpresso_0x0000.bin: unable to move extended attributes and ACL from 0242_lpc11u35_lpc824xpresso_0x0000.bin: No space left on device

posted by Karolis Misiunas 25 Nov 2016