Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
9 years, 7 months ago.
Can't install serial driver mbedWinSerial_16466.exe, message no mbed microcontrollers were found
Running Windows 7, 64 bit. Nucleo STM401RE board is plugged in and have downloaded programs to the board.
2 Answers
9 years, 7 months ago.
The nucleos need the ST link software driver. Follow the instructions on the start page. The nucleo serial port should show up in your windows device list. The mbedWinserial is for the original NXP type mbeds.
9 years, 7 months ago.
hi, is it these feature:
•STM32 microcontroller with LQFP64 package ◦STM32F401RET6 ( 512K FLASH ) •Two types of extension resources ◦Arduino Uno Revision 3 connectivity ◦STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os •mbed-enabled (mbed.org) •On-board ST-LINK/V2-1 debugger/programmer with SWD connector ◦selection-mode switch to use the kit as a standalone ST-LINK/V2-1 •Flexible board power supply ◦USB VBUS or external source(3.3 V, 5 V, 7 - 12 V) ◦Power management access point •Three LEDs ◦USB communication (LD1), user LED (LD2), power LED (LD3) •Two push buttons: USER and RESET •USB re-enumeration capability: three different interfaces supported on USB ◦Virtual Com port ◦Mass storage ◦Debug port •Comprehensive free software HAL library including a variety of software examples •Supported by wide choice of Integrated Development Environments (IDEs) including IAR, Keil, GCC-based IDEs
Hope that it can help you!
Best regards, Michella Sell Integrated circuits & smart watches& car dvr
Can't install serial driver mbedWinSerial_16466.exe, message no mbed microcontrollers were found
posted by rayco li 19 Jun 2017