Pierluigi Freni

Important changes to forums and questions

All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.

9 years ago.

nRF51822 debugging

Hi people,

I recently purchased the nRF51822-mKit (mbed Enabled) and I would like to debug an external nRF51822 target using the mKit board. So far I am able to program the flash of my target by dragging and dropping the hex file through the mKit board. The mKit board is connected to the target through the SWDIO and SWDCLK signals.

I look forward to hearing from you. Thank you very much for your consideration.

Stefano

Question relating to:

Last updated: 27 Aug 2020
The nRF51822-mKIT is a low cost ARM mbed enabled development board for Bluetooth® Smart designs with the nRF51822 SoC. The kit gives access to all GPIO pins via pin headers …

https://docs.mbed.com/docs/ble-intros/en/latest/Introduction/Debugging/

posted by Rohit Grover 26 Jan 2016

1 Answer

Rohit Grover
9 years ago.

Refer to https://docs.mbed.com/docs/ble-intros/en/latest/Introduction/Debugging/

Accepted Answer

That link is 404. Is there a correction?

posted by Thomas Olson 25 Jan 2016

https://docs.mbed.com/docs/ble-intros/en/latest/Introduction/Debugging/

posted by Rohit Grover 26 Jan 2016