Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
9 years, 4 months ago.
Why entering into bootloader mode always?
What could be the problem FRDM-K22 board always going in to bootloader mode even not pressing RESET while power on?
Thanks.
Question relating to:
1 Answer
Assigned to
9 years, 4 months ago.This means that the question has been accepted and is being worked on.
Sounds like the interface application isn't present. Give this a try. http://developer.mbed.org/handbook/Firmware-FRDM-K22F
posted by Sam Grove 15 Dec 2014Sam Grove,
My problem is still open. By mistake I assigned this question to my self.. I don;t to know how to to revert back to unassign
Thanks
posted by Vasavya Yagati 15 Dec 2014Connect scope and find out if reset line goes down, for how long and when.. I have seen it once , so there was added a delay (to wait until circuit stablizes)
posted by Martin Kojtal 16 Dec 2014