BLE nano doesn't work with UART

Questions » BLE nano doesn't work with UART

I have a RedbearLab BLE nano (firmware is updated) which has the "official" BLE_LoopbackUART project.

When I try to use it with the "nRF Toolbox" android app (Phone: Oneplus One 5.02 lollipop) I get these outputs:

"Service started

Connected to F4:83: .....

Services Discovered

Device is not supported (< the error)

Disconnected

Service destroyed"

When I use the same setup, but using the RedbearLab nRF51822, it all works completely fine.

I assume the problem is on the BLE nano.

Anyone with the same error?

Thanks!

1 Answer

I think you need to use the RedBearLab 's App to make the UART work. Nordic's nRFToolbox may have different configurations than the RedBearLab's App.

Asked 9 years, 7 months ago.

Updated 9 years, 7 months