Report
3 years, 8 months ago.

not enough storage

I tried to load the blinky program by drag and drop, but got error not enough storage only 2.5k How do I load programs

Question relating to:

Seeeduino Arch from Seeed Studio is an mbed enabled development board which combines some advantages of mbed and Arduino. Arch is based on NXP LPC11U24 with Arduino form factor and ...
Comment on this question

1 Answer

3 years, 8 months ago.

On the Seeeduino Arch: Long press reset to enter USB ISP mode, a CRP DISABLD disk will pop up. Delete firmware.bin file and save your program binary file produced by the online compiler instead. Press reset to start new code.

Thanks, I was afraid I would remove the bootloader.

posted by James Cullins 22 Jun 2015

To post an answer, please log in.