6 years, 11 months ago.

Connecting SeeedStduio Grove LCD

Hello, I'm new at Nucleo, but before I have been working on Arduino and everything was ok. When I came there, I'm trying to connect Grove LCD to Nucleo(this LCD have 2 signal wires(Rx,Tx) and 2 power:5(+ and GND). I foind library DigitDisplay which uses for example about grove shield guide on Nucleo's page on Mbed. Also, I asked for Tech.Support of SeeedStduio and they only said: try to connect lcd to outputs D14&D15(they are having I2C), but LCD continued to non-reacting to my commands. I'm asking him for brightness and echo some symbols

Question relating to:

Affordable and flexible platform to ease prototyping using a STM32F401RET6 microcontroller.
Be the first to answer this question.