Hi,
I try to setup TeraTerm to interact with mbed. I did everything according to the instruction from this link:
http://mbed.org/cookbook/Interfacing-Using-RPC
I was using following setting:
8 bits, 1 stop bit, no parity (aka 9600-8-N-1)
New-Line: Recive: LF, Transmit: CR+LF
Terminal ID: VT100
Everything was fine. If I hit Enter key, the Teraterm will return all the available RPC command/object. But the problem is that I can not enter any command directly into TeraTerm screen, the only way I can send command to mbed is to right click mouse to pop up a "Clipboard confirmation" window, and I can enter a command there.
I want to enter command directly in TeraTerm screen to send to mbed, is there anyway? how should I configure to do that?
Thank you very much.
Hi,
I try to setup TeraTerm to interact with mbed. I did everything according to the instruction from this link: http://mbed.org/cookbook/Interfacing-Using-RPC
I was using following setting: 8 bits, 1 stop bit, no parity (aka 9600-8-N-1) New-Line: Recive: LF, Transmit: CR+LF Terminal ID: VT100
Everything was fine. If I hit Enter key, the Teraterm will return all the available RPC command/object. But the problem is that I can not enter any command directly into TeraTerm screen, the only way I can send command to mbed is to right click mouse to pop up a "Clipboard confirmation" window, and I can enter a command there.
I want to enter command directly in TeraTerm screen to send to mbed, is there anyway? how should I configure to do that?
Thank you very much.