Tests to validate the proper implementation of the low power ticker. More...
Functions | |
| void | lp_ticker_info_test (void) |
| Test that the ticker has the correct frequency and number of bits. More... | |
| void | lp_ticker_deepsleep_test (void) |
| Test that the ticker continues operating in deep sleep mode. More... | |
| void | lp_ticker_glitch_test (void) |
| Test that the ticker does not glitch backwards due to an incorrectly implemented ripple counter driver. More... | |
Tests to validate the proper implementation of the low power ticker.
To run the low power ticker hal tests use the command:
mbed test -t <toolchain> -m <target> -n tests-mbed_hal-common_ticker*,tests-mbed_hal-lp_ticker*
| void lp_ticker_deepsleep_test | ( | void | ) |
Test that the ticker continues operating in deep sleep mode.
Given ticker is available. When ticker has interrupt set and board enters deep-sleep mode. Then ticker continues operating.
| void lp_ticker_glitch_test | ( | void | ) |
Test that the ticker does not glitch backwards due to an incorrectly implemented ripple counter driver.
Given ticker is available. When ticker is enabled and counts. Then ticker does not glitch backwards due to an incorrectly implemented ripple counter driver.
| void lp_ticker_info_test | ( | void | ) |
Test that the ticker has the correct frequency and number of bits.
Given ticker is available. When ticker information data is obtained. Then collected data indicates that ticker frequency is between 4KHz and 64KHz and the counter is at least 12 bits wide.
