Important changes to forums and questions
All forums and questions are now archived. To start a new conversation or read the latest updates go to forums.mbed.com.
10 years, 10 months ago.
Desoldering 402 sized components
What if I pull a pad? What type of solder did you use? What's the liquidous temp on it? (Lead free solder is higher temp.)
Question relating to:
2 Answers
10 years, 10 months ago.
Agree. Desoldering 0402 SJ1/SJ4 0R resistor from LPC812MAX is dangerous for me.
10 years, 10 months ago.
Just melt the solder, AND resistor, with just enough solder to bridge both pads
with a twist of the wrist, you can catch the resistor on the tip, and remove, do not try to keep the resistor,
use some fine solder braid, and a little no-clean flux, to remove excess solder,
then short out the other two pads, with just enough solder to bridge the pads.
Ceri