Report
1 week, 5 days ago.

LPC1768 cant start program

My LPC1768 suddenly stopped working. I can connect to it using USB cable, I can load a program to the mbed, but if I reset, there is no reaction. The 4 leds on the edge light very easily. The LED in close to USB light normally. I can also connect Putty on the USB Port. I re-updated the firmware and no problem. I almost finished my project and this happens. How can I get my LPC1768 working again? Thank you

Question relating to:

Rapid Prototyping for general microcontroller applications, Ethernet, USB and 32-bit ARM® Cortex™-M3 based designs
Comment on this question
Be the first to answer this question.

To post an answer, please log in.