first 2016/02 SDFileSystemDMA inherited from Official SDFileSystem.
Dependents: SDFileSystemDMA-test DmdFullRGB_0_1
Fork of SDFileSystemDMA by
SDFileSystemDMA is enhanced SDFileSystem library for STM32 micros by using DMA functionality.
Max read transfer rate reaches over 2MByte/sec at 24MHz SPI clock if enough read buffer size is set.
Even though minimum read buffer size (512Byte) is set, read transfer rate will reach over 1MByte/sec at 24MHz SPI Clock.
( but depends on the ability of each SD card)
Test program is here.
https://developer.mbed.org/users/mimi3/code/SDFileSystemDMA-test/
Supported SPI port is shown below table.
(v): Verified. It works well.
(w): Probably it will work well. (not tested)
(c): Only compiled. (not tested)
(f): Over flash.
(r): Only read mode. (when _FS_READONLY==1)
(u) Under construction
(z): Dose not work.
Caution
If your board has SRAM less than or equal to 8KB, the buffer size must be set to 512 Bytes.
Supported Boards:
Cortex-M0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
NUCLEO-F030R8 | 8KB | (v) | ||
DISCO-F051R8 | 8KB | (w) | ||
4KB | (f) | |||
NUCLEO-F042K6 | 6KB | (r) | ||
NUCLEO-F070RB | 16KB | (w) | ||
NUCLEO-F072RB | 16KB | (w) | ||
NUCLEO-F091RC | 32KB | (c) |
Cortex-L0
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-L053C8 | 8KB | (c) | ||
NUCLEO-L053R8 | 8KB | (c) | ||
NUCLEO-L073RZ | 20KB | (c) |
Cortex-M3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F100RB | 8KB | (v) | (v) | - |
BLUEPILL-F103CB | 20KB | (w) | (w) | - |
NUCLEO-F103RB | 20KB | (v) | (v) | - |
NUCLEO-L152RE | 80KB | (v) | (w) | - |
MOTE-L152RC | 32KB | (w) | (w) | - |
Cortex-M4
F3
Board | SRAM | SPI1 | SPI2 | SPI3 |
---|---|---|---|---|
DISCO-F303VC | 40KB | - | (v) | (v) |
NUCLEO-F303RE | 64KB | (w) | (w) | (w) |
NUCLEO-F302R8 | 16KB | - | - | (c) |
NUCLEO-F303K8 | 12KB | (c) | - | - |
DISCO-F334C8 | 12KB | (c) | - | - |
NUCLEO-F334R8 | 12KB | (c) | - | - |
F4
Board | SPI1 | SPI2 | SPI3 |
---|---|---|---|
ELMO-F411RE | (w) | - | (w) |
MTS-MDOT-F411RE | (u) | - | (u) |
MTS-DRAGONFLY-F411RE | (w) | - | (w) |
NUCLEO-F411RE | (v) | - | (v) |
NUCLEO-F401RE | (w) | - | (w) |
MTS-MDOT-F405RG | (u) | - | (u) |
NUCLEO-F410RB | (c) | - | (c) |
NUCLEO-F446RE | (c) | - | (c) |
NUCLEO-F429ZI | (c) | - | (c) |
B96B-F446VE | (c) | - | (c) |
NUCLEO-F446ZE | (c) | - | (c) |
DISCO-F429ZI | (u) | - | (u) |
DISCO-F469NI | (c) | - | (c) |
Information
This library is set to use "short file name" in SDFileSystemDMA/FATFileSystem/ChaN/ffconf.h . ( _USE_LFN=0)
You can change this option to _USE_LFN=1 .
Diff: SDFileSystemDMA.cpp
- Revision:
- 2:0e871408d51b
- Parent:
- 0:853a612ffb16
- Child:
- 3:23e0dcc750fe
--- a/SDFileSystemDMA.cpp Fri Feb 12 15:15:40 2016 +0000 +++ b/SDFileSystemDMA.cpp Sat Feb 13 18:50:11 2016 +0900 @@ -119,13 +119,13 @@ #define SD_DBG 0 -SDFileSystem::SDFileSystem(PinName mosi, PinName miso, PinName sclk, PinName cs, const char* name) : - FATFileSystem(name), _spi(mosi, miso, sclk), _cs(cs), _is_initialized(0) { +SDFileSystem::SDFileSystem(PinName mosi, PinName miso, PinName sclk, PinName cs, const char* name, int hz) : + FATFileSystem(name), _spi(mosi, miso, sclk), _cs(cs), _is_initialized(0), _transfer_sck(hz) { _cs = 1; // Set default to 100kHz for initialisation and 1MHz for data transfer _init_sck = 100000; - _transfer_sck = 12000000; + //_transfer_sck = 12000000; } #define R1_IDLE_STATE (1 << 0)