Diff: main.cpp

Revision:

8:c65afde7f7f5

Parent:

7:883da97339ab

Child:

9:3211e88e30a5

--- a/main.cpp	Tue Feb 05 15:01:00 2019 +0000
+++ b/main.cpp	Tue Feb 05 19:03:26 2019 +0000
@@ -7,9 +7,6 @@
  * CAN transceivers are not part of NUCLEO boards, therefore must be added by you.
  * Remember also that CAN bus (even a short one) must be terminated with 120 Ohm resitors at both ends.
  *
- * For more details see the wiki page <https://developer.mbed.org/users/hudakz/code/CAN_Hello/>
- *
- * NOTE: When using an STM32F103C8T6 board uncomment line 22 and import the mbed-STM32F103C8T6 library 
  *
  * The same code is used for both mbed boards, but:
  *      For board #1 compile the example without any change.
@@ -19,7 +16,7 @@
  *
  */
 
-//#define TARGET_STM32F103C8T6    1       // uncomment this line when using STM32F103C8T6 boards!
+//#define TARGET_STM32F103C8T6    1       // uncomment this line to use STM32F103C8T6 boards
 
 #define BOARD1                  1       // comment out this line when compiling for board #2
 
@@ -57,7 +54,7 @@
 float               voltage;
 
 /**
- * @brief   Prints CAN msg to PC's serial terminal
+ * @brief   Prints CAN message to PC's serial terminal
  * @note
  * @param   CANMessage to print
  * @retval
@@ -76,7 +73,7 @@
 
 /**
  * @brief   Handles received CAN messages
- * @note    Called on CAN msg received interrupt.
+ * @note    Called on 'CAN message received' interrupt.
  * @param
  * @retval
  */
@@ -87,13 +84,13 @@
 
     if (rxMsg.id == RX_ID) {
         // extract data from the received CAN message 
-        // in the same order as was added on the transmitter side
+        // in the same order as it was added on the transmitter side
         rxMsg >> counter;
         rxMsg >> voltage;    
         pc.printf("  counter = %d\r\n", counter);
         pc.printf("  voltage = %e V\r\n", voltage);
     }
-    timer.start(); // to transmit next message
+    timer.start(); // to transmit next message in main
 }
 
 
@@ -105,10 +102,10 @@
  */
 int main(void)
 {
-    pc.baud(9600);          // set Serial speed
-    can.frequency(1000000); // set bit rate to 1Mbps
+    pc.baud(9600);          // set serial speed
+    can.frequency(1000000); // set CAN bit rate to 1Mbps
     can.filter(RX_ID, 0xFFF, CANStandard, 0); // set filter #0 to accept only standard messages with ID == RX_ID
-    can.attach(onCanReceived);                // attach ISP
+    can.attach(onCanReceived);                // attach ISR to handle received messages
 
 #if defined(BOARD1)
     led = ON;               // turn the LED on