Library to control the EM027BS013 ePaper display from Pervasive Display.
File content as of revision 0:9297e33f50cf:
/** * \file * * \brief The EPD configurations * * Copyright (c) 2012-2014 Pervasive Displays Inc. All rights reserved. * * Authors: Pervasive Displays Inc. * * Redistribution and use in source and binary forms, with or without * modification, are permitted provided that the following conditions * are met: * * 1. Redistributions of source code must retain the above copyright * notice, this list of conditions and the following disclaimer. * 2. Redistributions in binary form must reproduce the above copyright * notice, this list of conditions and the following disclaimer in * the documentation and/or other materials provided with the * distribution. * * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE, * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE. */ #ifndef CONF_EPD_H_INCLUDED #define CONF_EPD_H_INCLUDED /** Define EPD_KIT_TOOL_FUNCTIONS if the code will work with EPD Kit Tool. * \note Comment out the #define below if you won't work with EPD Kit tool and * just want to show two images change alternately by predefined image array. */ //#define EPD_KIT_TOOL_FUNCTIONS /** \brief Supported COG version * * \note * - place the value here to assign which COG driving waveform will be used. * - Options are COG_V110_G1 and COG_V230_G2 */ //#define COG_V110_G1 #define COG_V230_G2 /** The SPI frequency of this kit (8MHz) */ #define COG_SPI_baudrate 8000000 /** Define the number of ram buffer for system packet used interchangeably*/ #define BUFFER_SIZE 1 /** System Packet length=6~64, maximum=64. * The payload length of MSP430 LaunchPad is 32 bytes only. * ======================== * | Byte | Name | * |------|---------------| * | 0 | Packet Header | * | 1 | Packet Length | * | 2-3 | Kit ID | * | 4 | Command Type | * | 5-62 | Data | * | 63 | CRC | */ #define PAYLOAD_SIZE 32 /** Firmware version to display on EPD Kit Tool */ #define EPD_KIT_TOOL_VERSION "1.11 " /** \brief Kit ID for recognizing by EPD Kit Tool * * \note * - High byte is IC vendor, low byte is the name of supported development kit * - Texas Instruments=01, MSP430 LaunchPad=01 */ #define EPD_KIT_TOOL_ID (uint16_t)0x0101 #endif /* CONF_EPD_H_INCLUDED */