Damian Gabino
MCU driver/HAL for the Picocell Gateway concentrator board. The firmware implements either a USB CDC protocol or a UART protocol to bridge commands coming from host to the SX1308 SPI interface.
Diff: src/usb_cdc/Inc/usbd_def.h
- Revision:
- 0:c76361bd82e8
--- /dev/null Thu Jan 01 00:00:00 1970 +0000
+++ b/src/usb_cdc/Inc/usbd_def.h Wed Apr 11 14:42:47 2018 +0000
@@ -0,0 +1,330 @@
+/**
+ ******************************************************************************
+ * @file usbd_def.h
+ * @author MCD Application Team
+ * @version V2.4.2
+ * @date 11-December-2015
+ * @brief General defines for the usb device library
+ ******************************************************************************
+ * @attention
+ *
+ * <h2><center>© COPYRIGHT 2015 STMicroelectronics</center></h2>
+ *
+ * Licensed under MCD-ST Liberty SW License Agreement V2, (the "License");
+ * You may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at:
+ *
+ * http://www.st.com/software_license_agreement_liberty_v2
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS,
+ * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ *
+ ******************************************************************************
+ */
+
+/* Define to prevent recursive inclusion -------------------------------------*/
+#ifndef __USBD_DEF_H
+#define __USBD_DEF_H
+
+#ifdef __cplusplus
+ extern "C" {
+#endif
+
+/* Includes ------------------------------------------------------------------*/
+#include "usbd_conf.h"
+
+/** @addtogroup STM32_USBD_DEVICE_LIBRARY
+ * @{
+ */
+
+/** @defgroup USB_DEF
+ * @brief general defines for the usb device library file
+ * @{
+ */
+
+/** @defgroup USB_DEF_Exported_Defines
+ * @{
+ */
+
+#ifndef NULL
+#define NULL 0
+#endif
+
+
+#define USB_LEN_DEV_QUALIFIER_DESC 0x0A
+#define USB_LEN_DEV_DESC 0x12
+#define USB_LEN_CFG_DESC 0x09
+#define USB_LEN_IF_DESC 0x09
+#define USB_LEN_EP_DESC 0x07
+#define USB_LEN_OTG_DESC 0x03
+#define USB_LEN_LANGID_STR_DESC 0x04
+#define USB_LEN_OTHER_SPEED_DESC_SIZ 0x09
+
+#define USBD_IDX_LANGID_STR 0x00
+#define USBD_IDX_MFC_STR 0x01
+#define USBD_IDX_PRODUCT_STR 0x02
+#define USBD_IDX_SERIAL_STR 0x03
+#define USBD_IDX_CONFIG_STR 0x04
+#define USBD_IDX_INTERFACE_STR 0x05
+
+#define USB_REQ_TYPE_STANDARD 0x00
+#define USB_REQ_TYPE_CLASS 0x20
+#define USB_REQ_TYPE_VENDOR 0x40
+#define USB_REQ_TYPE_MASK 0x60
+
+#define USB_REQ_RECIPIENT_DEVICE 0x00
+#define USB_REQ_RECIPIENT_INTERFACE 0x01
+#define USB_REQ_RECIPIENT_ENDPOINT 0x02
+#define USB_REQ_RECIPIENT_MASK 0x03
+
+#define USB_REQ_GET_STATUS 0x00
+#define USB_REQ_CLEAR_FEATURE 0x01
+#define USB_REQ_SET_FEATURE 0x03
+#define USB_REQ_SET_ADDRESS 0x05
+#define USB_REQ_GET_DESCRIPTOR 0x06
+#define USB_REQ_SET_DESCRIPTOR 0x07
+#define USB_REQ_GET_CONFIGURATION 0x08
+#define USB_REQ_SET_CONFIGURATION 0x09
+#define USB_REQ_GET_INTERFACE 0x0A
+#define USB_REQ_SET_INTERFACE 0x0B
+#define USB_REQ_SYNCH_FRAME 0x0C
+
+#define USB_DESC_TYPE_DEVICE 1
+#define USB_DESC_TYPE_CONFIGURATION 2
+#define USB_DESC_TYPE_STRING 3
+#define USB_DESC_TYPE_INTERFACE 4
+#define USB_DESC_TYPE_ENDPOINT 5
+#define USB_DESC_TYPE_DEVICE_QUALIFIER 6
+#define USB_DESC_TYPE_OTHER_SPEED_CONFIGURATION 7
+#define USB_DESC_TYPE_BOS 0x0F
+
+#define USB_CONFIG_REMOTE_WAKEUP 2
+#define USB_CONFIG_SELF_POWERED 1
+
+#define USB_FEATURE_EP_HALT 0
+#define USB_FEATURE_REMOTE_WAKEUP 1
+#define USB_FEATURE_TEST_MODE 2
+
+#define USB_DEVICE_CAPABITY_TYPE 0x10
+
+#define USB_HS_MAX_PACKET_SIZE 512
+#define USB_FS_MAX_PACKET_SIZE 256
+#define USB_MAX_EP0_SIZE 64
+
+/* Device Status */
+#define USBD_STATE_DEFAULT 1
+#define USBD_STATE_ADDRESSED 2
+#define USBD_STATE_CONFIGURED 3
+#define USBD_STATE_SUSPENDED 4
+
+
+/* EP0 State */
+#define USBD_EP0_IDLE 0
+#define USBD_EP0_SETUP 1
+#define USBD_EP0_DATA_IN 2
+#define USBD_EP0_DATA_OUT 3
+#define USBD_EP0_STATUS_IN 4
+#define USBD_EP0_STATUS_OUT 5
+#define USBD_EP0_STALL 6
+
+#define USBD_EP_TYPE_CTRL 0
+#define USBD_EP_TYPE_ISOC 1
+#define USBD_EP_TYPE_BULK 2
+#define USBD_EP_TYPE_INTR 3
+
+
+/**
+ * @}
+ */
+
+
+/** @defgroup USBD_DEF_Exported_TypesDefinitions
+ * @{
+ */
+
+typedef struct usb_setup_req
+{
+
+ uint8_t bmRequest;
+ uint8_t bRequest;
+ uint16_t wValue;
+ uint16_t wIndex;
+ uint16_t wLength;
+}USBD_SetupReqTypedef;
+
+struct _USBD_HandleTypeDef;
+
+typedef struct _Device_cb
+{
+ uint8_t (*Init) (struct _USBD_HandleTypeDef *pdev , uint8_t cfgidx);
+ uint8_t (*DeInit) (struct _USBD_HandleTypeDef *pdev , uint8_t cfgidx);
+ /* Control Endpoints*/
+ uint8_t (*Setup) (struct _USBD_HandleTypeDef *pdev , USBD_SetupReqTypedef *req);
+ uint8_t (*EP0_TxSent) (struct _USBD_HandleTypeDef *pdev );
+ uint8_t (*EP0_RxReady) (struct _USBD_HandleTypeDef *pdev );
+ /* Class Specific Endpoints*/
+ uint8_t (*DataIn) (struct _USBD_HandleTypeDef *pdev , uint8_t epnum);
+ uint8_t (*DataOut) (struct _USBD_HandleTypeDef *pdev , uint8_t epnum);
+ uint8_t (*SOF) (struct _USBD_HandleTypeDef *pdev);
+ uint8_t (*IsoINIncomplete) (struct _USBD_HandleTypeDef *pdev , uint8_t epnum);
+ uint8_t (*IsoOUTIncomplete) (struct _USBD_HandleTypeDef *pdev , uint8_t epnum);
+
+ uint8_t *(*GetHSConfigDescriptor)(uint16_t *length);
+ uint8_t *(*GetFSConfigDescriptor)(uint16_t *length);
+ uint8_t *(*GetOtherSpeedConfigDescriptor)(uint16_t *length);
+ uint8_t *(*GetDeviceQualifierDescriptor)(uint16_t *length);
+#if (USBD_SUPPORT_USER_STRING == 1)
+ uint8_t *(*GetUsrStrDescriptor)(struct _USBD_HandleTypeDef *pdev ,uint8_t index, uint16_t *length);
+#endif
+
+} USBD_ClassTypeDef;
+
+/* Following USB Device Speed */
+typedef enum
+{
+ USBD_SPEED_HIGH = 0,
+ USBD_SPEED_FULL = 1,
+ USBD_SPEED_LOW = 2,
+}USBD_SpeedTypeDef;
+
+/* Following USB Device status */
+typedef enum {
+ USBD_OK = 0,
+ USBD_BUSY,
+ USBD_FAIL,
+}USBD_StatusTypeDef;
+
+/* USB Device descriptors structure */
+typedef struct
+{
+ uint8_t *(*GetDeviceDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetLangIDStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetManufacturerStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetProductStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetSerialStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetConfigurationStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+ uint8_t *(*GetInterfaceStrDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+#if (USBD_LPM_ENABLED == 1)
+ uint8_t *(*GetBOSDescriptor)( USBD_SpeedTypeDef speed , uint16_t *length);
+#endif
+} USBD_DescriptorsTypeDef;
+
+/* USB Device handle structure */
+typedef struct
+{
+ uint32_t status;
+ uint32_t total_length;
+ uint32_t rem_length;
+ uint32_t maxpacket;
+} USBD_EndpointTypeDef;
+
+/* USB Device handle structure */
+typedef struct _USBD_HandleTypeDef
+{
+ uint8_t id;
+ uint32_t dev_config;
+ uint32_t dev_default_config;
+ uint32_t dev_config_status;
+ USBD_SpeedTypeDef dev_speed;
+ USBD_EndpointTypeDef ep_in[15];
+ USBD_EndpointTypeDef ep_out[15];
+ uint32_t ep0_state;
+ uint32_t ep0_data_len;
+ uint8_t dev_state;
+ uint8_t dev_old_state;
+ uint8_t dev_address;
+ uint8_t dev_connection_status;
+ uint8_t dev_test_mode;
+ uint32_t dev_remote_wakeup;
+
+ USBD_SetupReqTypedef request;
+ USBD_DescriptorsTypeDef *pDesc;
+ USBD_ClassTypeDef *pClass;
+ void *pClassData;
+ void *pUserData;
+ void *pData;
+} USBD_HandleTypeDef;
+
+/**
+ * @}
+ */
+
+
+
+/** @defgroup USBD_DEF_Exported_Macros
+ * @{
+ */
+#define SWAPBYTE(addr) (((uint16_t)(*((uint8_t *)(addr)))) + \
+ (((uint16_t)(*(((uint8_t *)(addr)) + 1))) << 8))
+
+#define LOBYTE(x) ((uint8_t)(x & 0x00FF))
+#define HIBYTE(x) ((uint8_t)((x & 0xFF00) >>8))
+#define MIN(a, b) (((a) < (b)) ? (a) : (b))
+#define MAX(a, b) (((a) > (b)) ? (a) : (b))
+
+
+#if defined ( __GNUC__ )
+ #ifndef __weak
+ #define __weak __attribute__((weak))
+ #endif /* __weak */
+ #ifndef __packed
+ #define __packed __attribute__((__packed__))
+ #endif /* __packed */
+#endif /* __GNUC__ */
+
+
+/* In HS mode and when the DMA is used, all variables and data structures dealing
+ with the DMA during the transaction process should be 4-bytes aligned */
+
+#if defined (__GNUC__) /* GNU Compiler */
+ #define __ALIGN_END __attribute__ ((aligned (4)))
+ #define __ALIGN_BEGIN
+#else
+ #define __ALIGN_END
+ #if defined (__CC_ARM) /* ARM Compiler */
+ #define __ALIGN_BEGIN __align(4)
+ #elif defined (__ICCARM__) /* IAR Compiler */
+ #define __ALIGN_BEGIN
+ #elif defined (__TASKING__) /* TASKING Compiler */
+ #define __ALIGN_BEGIN __align(4)
+ #endif /* __CC_ARM */
+#endif /* __GNUC__ */
+
+
+/**
+ * @}
+ */
+
+/** @defgroup USBD_DEF_Exported_Variables
+ * @{
+ */
+
+/**
+ * @}
+ */
+
+/** @defgroup USBD_DEF_Exported_FunctionsPrototype
+ * @{
+ */
+
+/**
+ * @}
+ */
+
+#ifdef __cplusplus
+}
+#endif
+
+#endif /* __USBD_DEF_H */
+
+/**
+ * @}
+ */
+
+/**
+* @}
+*/
+/************************ (C) COPYRIGHT STMicroelectronics *****END OF FILE****/