File content as of revision 71:7b5ebd969aa7:

================================================================================
=                            Mbed Host Firmware                                =
=                                                                              =
=                              Release notes                                   =
================================================================================
================================================================================
v01.17.0075 (20 April 2020)
--------------------------------------------------------------------------------
- Removed CRC field in LUT
- Adding 31us delay between wakeup signal and SPI's CS signal
- Code clean up
- Handling FIFO error
================================================================================
v01.02.0003 (6 March 2020)
--------------------------------------------------------------------------------
- SPI malfunctions after hibernation
- SPI frequency set to 1MHz
================================================================================
v01.02.0002 (25 February 2020)
--------------------------------------------------------------------------------
- Added support to load Look up table 
- Printing correct Raw values from the sensor
- Added funcionality to read the Mbed FW version 
- Added release notes
- updated all the config files
================================================================================

v01.01.0001 (18 February 2020)
--------------------------------------------------------------------------------
- Changed ADMW_CONFIG struct variable name to "meassureware_config" inroder to load the config/design file downloaded from MW designer
- Added wakeup functinality support.
- Added support for ADT7420
- Added support for DRDY_PER_FIFO_FILL mode
- Supporting the the Device FW v1.12.061
================================================================================