Jonne Valola / PokittoLib Featured

PokittoLib is the library needed for programming the Pokitto DIY game console (www.pokitto.com)

Dependents:   YATTT sd_map_test cPong SnowDemo ... more

PokittoLib

Library for programming Pokitto hardware

How to Use

  1. Import this library to online compiler (see button "import" on the right hand side
  2. DO NOT import mbed-src anymore, a better version is now included inside PokittoLib
  3. Change My_settings.h according to your project
  4. Start coding!

mbed-pokitto/common/board.c

Committer:
Pokitto
Date:
2019-12-25
Revision:
71:531419862202
Parent:
5:ea7377f3d1af

File content as of revision 71:531419862202:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#include "gpio_api.h"
#include "wait_api.h"
#include "toolchain.h"
#include "mbed_interface.h"

WEAK void mbed_die(void) {
#if !defined (NRF51_H) && !defined(TARGET_EFM32)
	__disable_irq();	// dont allow interrupts to disturb the flash pattern
#endif
#if   (DEVICE_ERROR_RED == 1)
    gpio_t led_red; gpio_init_out(&led_red, LED_RED);
#elif (DEVICE_ERROR_PATTERN == 1)
    gpio_t led_1; gpio_init_out(&led_1, LED1);
    gpio_t led_2; gpio_init_out(&led_2, LED2);
    gpio_t led_3; gpio_init_out(&led_3, LED3);
    gpio_t led_4; gpio_init_out(&led_4, LED4);
#endif

    while (1) {
#if   (DEVICE_ERROR_RED == 1)
        gpio_write(&led_red, 1);

#elif (DEVICE_ERROR_PATTERN == 1)
        gpio_write(&led_1, 1);
        gpio_write(&led_2, 0);
        gpio_write(&led_3, 0);
        gpio_write(&led_4, 1);
#endif

        wait_ms(150);

#if   (DEVICE_ERROR_RED == 1)
        gpio_write(&led_red, 0);

#elif (DEVICE_ERROR_PATTERN == 1)
        gpio_write(&led_1, 0);
        gpio_write(&led_2, 1);
        gpio_write(&led_3, 1);
        gpio_write(&led_4, 0);
#endif

        wait_ms(150);
    }
}