File content as of revision 44:544add59b26d:

Tasks we needs to be done.
Move finished tasks to Done section:

- Make the timers more generic and move the OS code into the HAL layer.
- add support for Arduino - add sx1276-Arduino-hal.h/cpp
- add support for Linux - add sx1276-Linux-hal.h/cpp
- Add support for Cad detection before sending a packet
- Add support to provide the send/receive packet buffer,
  no need to allocate packet data in the sx1276 driver. Can be provided
  Rx/Tx parameters.
- Add support for larger Lora packets (can be up to 2048 bytes)
  this feature is not so important, however the current implementation
  is very basic.
- It is a little bit strange that RX/TX/Cad Timeout Timer calling the
  some handler OnTimeoutIrq. Maybe we just need a single timer, or 
  it is a good idea to split the OnTimeoutIrq function
- Test if the SX1276 timeouts (rx(tx/sync really uses three timers or
  just one at a time.


Done:
- Started a Generic SX1276 driver to support all SX1276 modules (May-2017 Helmut)
- Migrated typedefs code into sx1276.h (7-May-2017 Helmut)
- Migrated enum code into sx1276.h/radio.h (7-May-2017 Helmut)
- Verify the Murata ANT Switch code
- MURATA PA_BOOST case,is _antSwitchTXBoost right? (Same as STM sample code)
- Check of the MURATA TCXO config is correct (implemented, check JP9 on STM L0 board)