BLE_API wrapper library for STMicroelectronics' BlueNRG Bluetooth Low Energy expansion board shield (Component)
Dependents: Nucleo_Zumo_BLE_IDB04A1 contest_IOT5 contest_IOT6 contest_IOT_10 ... more
Fork of X_NUCLEO_IDB0XA1 by
Arduino Connector Compatibility Warning
X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 are Arduino compatible with an exception: instead of using pin D13
for the SPI clock, they use pin D3
.
The default configuration for this library is having the SPI clock on pin D3
.
To be fully Arduino compatible, X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 need a small HW patch.
For X-NUCLEO-IDB04A1 this patch consists in removing zero resistor R10
and instead soldering zero resistor R11
.
For X-NUCLEO-IDB05A1 this patch consists in removing zero resistor R4
and instead soldering zero resistor R6
.
In case you patch your board, then you also have to configure this library to use pin D13
to drive the SPI clock (see macro IDB0XA1_D13_PATCH
in file x_nucleo_idb0xa1_targets.h
).
If you use pin D13
for the SPI clock, please be aware that on STM32 Nucleo boards you may not drive the LED, otherwise you will get a conflict: the LED on STM32 Nucleo boards is connected to pin D13
.
Referring to the current list of tested platforms (see X-NUCLEO-IDB04A1 and X-NUCLEO-IDB05A1 pages), the patch is required by ST-Nucleo-F103RB; ST-Nucleo-F302R8; ST-Nucleo-F411RE; and ST-Nucleo-F446RE.
Diff: source/BlueNRGGap.cpp
- Revision:
- 213:781abfbf2d1c
- Parent:
- 210:08c4c85ca679
- Child:
- 215:e8fa3129410a
- Child:
- 217:23870c55b07e
--- a/source/BlueNRGGap.cpp Thu Jan 14 10:59:36 2016 +0100 +++ b/source/BlueNRGGap.cpp Fri Mar 18 12:05:22 2016 +0100 @@ -283,6 +283,21 @@ //Set the SCAN_RSP Payload scan_response_payload = scanResponse.getPayload(); scan_rsp_length = scanResponse.getPayloadLen(); + + // Update the ADV data if we are already in ADV mode + if(AdvLen > 0 && state.advertising == 1) { + + tBleStatus ret = aci_gap_update_adv_data(AdvLen, AdvData); + if(BLE_STATUS_SUCCESS!=ret) { + PRINTF("error occurred while adding adv data (ret=0x%x)\n", ret); + switch (ret) { + case BLE_STATUS_TIMEOUT: + return BLE_STACK_BUSY; + default: + return BLE_ERROR_UNSPECIFIED; + } + } + } } return BLE_ERROR_NONE; }