Library to handle the X-NUCLEO-6180XA1 Proximity and ambient light sensor expansion board based on VL6180X.
Fork of X_NUCLEO_6180XA1 by
X-NUCLEO-6180XA1 Proximity and Ambient Light Sensor Expansion Board Firmware Package
This firmware package includes Components Device Drivers and Board Support Package for STMicroelectronics' X-NUCLEO-6180XA1 Proximity and ambient light sensor expansion board based on VL6180X.
Class X_NUCLEO_6180XA1 is intended to represent the Proximity and ambient light sensor expansion board with the same name.
The expansion board is providing the support of the following components:
- on-board VL6180X proximity and ambient light sensor,
- up to three additional VL6180X Satellites,
- on-board 4-digit display
It is intentionally implemented as a singleton because only one X-NUCLEO-VL6180XA1 at a time might be deployed in a HW component stack. In order to get the singleton instance you have to call class method `Instance()`, e.g.:
// Sensors expansion board singleton instance static X_NUCLEO_6180XA1 *6180X_expansion_board = X_NUCLEO_6180XA1::Instance();
Arduino Connector Compatibility Warning
Using the X-NUCLEO-6180XA1 expansion board with the
NUCLEO-F429ZI requires adopting the following patch:
- to remove R46 resistor connected to
- to solder R47 resistor connected to
Alternatively, you can route the Nucleo board’s
A5 pin directly to the expansion board’s
A3 pin with a wire.
In case you patch your expansion board or route the pin, the interrupt signal for the front sensor will be driven on
A5 pin rather than on
ST_INTERFACES.lib@58:1e9a3a46f814, 2017-08-21 (annotated)
- Mon Aug 21 15:44:34 2017 +0000
Make compatible with non-copyable version of I2C.
Who changed what in which revision?
|User||Revision||Line number||New contents of line|