Rigado / mbed-src-bmd-200

mbed-src updated for BMD-200 evaluation board. Just pin numbers are updated.

Dependents:   mbed_blinky-bmd-200 bmd-200_accel_demo firstRig

Fork of mbed-src by mbed official

Replacement for the "mbed" or "mbed-src" library when using the BMD-200 Evaluation kit. This library only remaps the pin names (i.e. LED1 points to p0.01 instead of p0.18, etc) as used by the BMD-200 Evaluation board (select the nRF51822_mkit platform). All other code is untouched.

hal/serial_api.h

Committer:
emilmont
Date:
2013-06-10
Revision:
9:0ce32e54c9a7
Parent:
capi/serial_api.h@ 2:143cac498751
Child:
10:3bc89ef62ce7

File content as of revision 9:0ce32e54c9a7:

/* mbed Microcontroller Library
 * Copyright (c) 2006-2013 ARM Limited
 *
 * Licensed under the Apache License, Version 2.0 (the "License");
 * you may not use this file except in compliance with the License.
 * You may obtain a copy of the License at
 *
 *     http://www.apache.org/licenses/LICENSE-2.0
 *
 * Unless required by applicable law or agreed to in writing, software
 * distributed under the License is distributed on an "AS IS" BASIS,
 * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
 * See the License for the specific language governing permissions and
 * limitations under the License.
 */
#ifndef MBED_SERIAL_API_H
#define MBED_SERIAL_API_H

#include "device.h"

#if DEVICE_SERIAL

#ifdef __cplusplus
extern "C" {
#endif

typedef enum {
    ParityNone = 0,
    ParityOdd = 1,
    ParityEven = 2,
    ParityForced1 = 3,
    ParityForced0 = 4
} SerialParity;

typedef enum {
    RxIrq,
    TxIrq
} SerialIrq;

typedef void (*uart_irq_handler)(uint32_t id, SerialIrq event);

typedef struct serial_s serial_t;

void serial_init       (serial_t *obj, PinName tx, PinName rx);
void serial_free       (serial_t *obj);
void serial_baud       (serial_t *obj, int baudrate);
void serial_format     (serial_t *obj, int data_bits, SerialParity parity, int stop_bits);

void serial_irq_handler(serial_t *obj, uart_irq_handler handler, uint32_t id);
void serial_irq_set    (serial_t *obj, SerialIrq irq, uint32_t enable);

int  serial_getc       (serial_t *obj);
void serial_putc       (serial_t *obj, int c);
int  serial_readable   (serial_t *obj);
int  serial_writable   (serial_t *obj);
void serial_clear      (serial_t *obj);

void serial_pinout_tx(PinName tx);

#ifdef __cplusplus
}
#endif

#endif

#endif