I messed up the merge, so pushing it over to another repo so I don't lose it. Will tidy up and remove later
Dependencies: BufferedSerial FatFileSystemCpp mbed
settings.txt
- Committer:
- AndyA
- Date:
- 2021-08-17
- Revision:
- 50:d6c56eccf56a
- Parent:
- 47:8d577dfb7eb1
- Child:
- 51:d4a5151af5af
File content as of revision 50:d6c56eccf56a:
[Serial Output Format] # Sets the serial output format. # 0 = VIPS (Default) # 1 = FreeD -------------------------------- Output_Format=0 -------------------------------- [Fiz Format] # Sets the FIZ reader to use # 0 - Preston (default) # 1 - Fuji passive listen mode (skycam) # 2 - Fuji active mode # 3 - Canon -------------------------------- FIZ_Format=3 -------------------------------- [Ethernet Port] # Sets the UDP port for FreeD network output. # Data is sent as a UDP broadcast on the select port number. # A port number of 0 disables UDP output. -------------------------------- FreeD_Port=12345 VIPS_UDP_Port=7000 -------------------------------- [Network Settings] # Set the Static IPv4 address to use for the ethernet interface. # NOTE: All 3 values must be set for a static address to be used otherwise DHCP will be used. # Comment out the line using any additional characters at the beginning to ignore -------------------------------- //IP_addr=aaa.bbb.ccc.ddd //Subnet=aaa.bbb.ccc.ddd //Gateway=aaa.bbb.ccc.ddd -------------------------------- [Filter_Settings] #Low pass filter settings for channels that have it enabled. #Filter is of order n with a cut off at m Hz assuming input data rate is at r Hz #Filter order must be set to enable filters. #Frequency default is 10Hz #Rate default is 100Hz //FilterOrder=1 //FilterFreq=7 //FilterRate=100 //FilterXY=0 //FilterZ=0 //FilterRoll=0 //FilterPitch=1 //FilterYaw=0 # Enable channels to low pass filter. All filters use the settings given above. # A value of 1 enables the filter. A value of 0 or skipping the line disables the filter. # NOTE-The filter will add latency so a filtered channel will be delayed relative to an unfiltered one. [Additional outputs] # By default FIZ box VIPS format output only output the fields required by unreal # even if the VIPS itself is configured to output more data. This is intended to minimise radio traffic # while allowing debug data to be avalible when connecting directly to VIPS. # Setting this option to 1 allows additional fields to be passed through the FIZ box. # Currently supported fields are: # Used Beacon List (mask value 0x1000) //ExtendedOutput=1 # By default the FIZ output is sent as soon as possible after the sync pulse. # An optional delay can be added to this to either as time or as a proportion of a frame # If both ms and frame delays are set then the frame one will be used. # NOTE: UDP output has an aditional jitter/delay of up to 2ms due to the thread sleep times. # BIG FLASHING NOTE IN BOLD: No additional buffering is provided so if delay is sufficently large # that the transmit doesn't complete until after the next frame starts # then the message will get corrupted. # Delay the serial by a fixed number of ms //DelaySerial=5.2 # Delay the serial by a fraction of a frame //DelaySerialFrame=0.3 # Delay the serial by a fixed number of ms //DelayUDP=5.2 # Delay the serial by a fraction of a frame //DelayUDPFrame=0.3 [NOTES] - All settings are case sensitive. - Do NOT include spaces in the options lines. - All options default to a value of 0 if omitted from the file.