Diff: source/hic_hal/nxp/lpc4322/lpc43xx_scu.h

Revision:

0:01f31e923fe2

diff -r 000000000000 -r 01f31e923fe2 source/hic_hal/nxp/lpc4322/lpc43xx_scu.h
--- /dev/null	Thu Jan 01 00:00:00 1970 +0000
+++ b/source/hic_hal/nxp/lpc4322/lpc43xx_scu.h	Tue Apr 07 12:55:42 2020 +0200
@@ -0,0 +1,125 @@
+/**
+ * @file    lpc43xx_scu.h
+ * @brief   
+ *
+ * DAPLink Interface Firmware
+ * Copyright (c) 2009-2016, ARM Limited, All Rights Reserved
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License"); you may
+ * not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing, software
+ * distributed under the License is distributed on an "AS IS" BASIS, WITHOUT
+ * WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+ * See the License for the specific language governing permissions and
+ * limitations under the License.
+ */
+
+/* Peripheral group ----------------------------------------------------------- */
+/** @defgroup SCU	SCU (System Control Unit)
+ * @ingroup LPC4300CMSIS_FwLib_Drivers
+ * @{
+ */
+
+#ifndef __SCU_H
+#define __SCU_H
+
+#ifdef __cplusplus
+extern "C"
+{
+#endif
+
+/* Private macros ------------------------------------------------------------- */
+/** @defgroup SCT_Private_Macros SCT Private Macros
+ * @{
+ */
+
+/** Port offset definition */
+#define PORT_OFFSET 	0x80
+/** Pin offset definition */
+#define PIN_OFFSET  	0x04
+
+/* Pin mode defines, following partly a definition from older chip architectures */
+#define MD_PUP  (0x0 << 3)
+#define MD_BUK  (0x1 << 3)
+#define MD_PLN  (0x2 << 3)
+#define MD_PDN  (0x3 << 3)
+#define MD_EHS  (0x1 << 5)
+#define MD_EZI  (0x1 << 6)
+#define MD_ZI   (0x1 << 7)
+#define MD_EHD0 (0x1 << 8)
+#define MD_EHD1 (0x1 << 9)
+#define MD_EHD2 (0x3 << 8)
+#define MD_PLN_FAST (MD_PLN | MD_EZI | MD_ZI | MD_EHS)
+
+
+/* Pin mode defines, more in line with the definitions in the LPC1800/4300 user manual */
+/* Defines for SFSPx_y pin configuration registers                                     */
+#define PDN_ENABLE        (1 << 3)	// Pull-down enable
+#define PDN_DISABLE       (0 << 3)      // Pull-down disable
+#define PUP_ENABLE        (0 << 4)      // Pull-up enable
+#define PUP_DISABLE       (1 << 4)	// Pull-up disable
+#define SLEWRATE_SLOW	  (0 << 5)	// Slew rate for low noise with medium speed
+#define SLEWRATE_FAST	  (1 << 5)	// Slew rate for medium noise with fast speed
+#define INBUF_ENABLE	  (1 << 6)	// Input buffer
+#define INBUF_DISABLE	  (0 << 6)	// Input buffer
+#define FILTER_ENABLE	  (0 << 7)	// Glitch filter (for signals below 30MHz)
+#define FILTER_DISABLE	  (1 << 7)	// No glitch filter (for signals above 30MHz)
+#define DRIVE_8MA         (1 << 8)	// Drive strength of 8mA
+#define DRIVE_14MA        (1 << 9)	// Drive strength of 14mA
+#define DRIVE_20MA        (3 << 8)	// Drive strength of 20mA
+
+
+/* Configuration examples for various I/O pins */
+#define EMC_IO	        (PUP_ENABLE  | PDN_ENABLE  | SLEWRATE_FAST | INBUF_ENABLE  | FILTER_DISABLE)
+#define LCD_PINCONFIG   (PUP_DISABLE | PDN_DISABLE | SLEWRATE_FAST | INBUF_ENABLE  | FILTER_DISABLE)
+#define CLK_IN	        (PUP_ENABLE  | PDN_ENABLE  | SLEWRATE_FAST | INBUF_ENABLE  | FILTER_DISABLE)
+#define CLK_OUT	        (PUP_ENABLE  | PDN_ENABLE  | SLEWRATE_FAST | INBUF_ENABLE  | FILTER_DISABLE)
+#define GPIO_PUP	(PUP_ENABLE  | PDN_DISABLE | SLEWRATE_SLOW | INBUF_ENABLE  | FILTER_ENABLE )
+#define GPIO_PDN	(PUP_DISABLE | PDN_ENABLE  | SLEWRATE_SLOW | INBUF_ENABLE  | FILTER_ENABLE )
+#define GPIO_NOPULL	(PUP_DISABLE | PDN_DISABLE | SLEWRATE_SLOW | INBUF_ENABLE  | FILTER_ENABLE )
+#define UART_RX_TX	(PUP_DISABLE | PDN_ENABLE  | SLEWRATE_SLOW | INBUF_ENABLE  | FILTER_ENABLE )
+#define SSP_IO	        (PUP_ENABLE  | PDN_ENABLE  | SLEWRATE_FAST | INBUF_ENABLE  | FILTER_DISABLE)
+
+
+/* Pin function */
+#define FUNC0 			0x0				/** Function 0 	*/
+#define FUNC1 			0x1				/** Function 1 	*/
+#define FUNC2 			0x2				/** Function 2	*/
+#define FUNC3 			0x3				/** Function 3	*/
+#define FUNC4			0x4
+#define FUNC5			0x5
+#define FUNC6			0x6
+#define FUNC7			0x7
+/**
+ * @}
+ */
+
+#define LPC_SCU_PIN(po, pi)   (*(volatile int         *) (LPC_SCU_BASE + ((po) * 0x80) + ((pi) * 0x4))    )
+#define LPC_SCU_CLK(c)        (*(volatile int         *) (LPC_SCU_BASE + 0xC00 + ((c) * 0x4))    )
+
+/* Public Functions ----------------------------------------------------------- */
+/** @defgroup SCU_Public_Functions SCU Public Functions
+ * @{
+ */
+
+void scu_pinmux(uint8_t port, uint8_t pin, uint8_t mode, uint8_t func);
+
+/**
+ * @}
+ */
+
+#ifdef __cplusplus
+}
+#endif
+
+#endif /* end __SCU_H */
+
+/**
+ * @}
+ */
+