File content as of revision 8:2e0e9b520392:

Evaluation Boards/Products Supported
------------------------------------ 
EVAL-AD4111SDZ
EVAL-AD4112SDZ
EVAL-AD4114/15SDZ
EVAL-AD7175-2
EVAL-AD7175-8
EVAL-AD7176-2
EVAL-AD7177-2
EVAL-AD7172-2
EVAL-AD7172-4
EVAL-AD7173-8SDZ
 
 
Overview
--------
These code files provide the console application and device libraries to 
interface with AD717x/AD411x EVAL boards. This code was developed and tested on SDP-K1 
controller board: https://os.mbed.com/platforms/SDP_K1/
 
Product details: https://www.analog.com/en/products/ad4111.html
                 https://www.analog.com/en/products/ad4112.html
                 https://www.analog.com/en/products/ad4115.html
                 https://www.analog.com/en/products/landing-pages/001/ad717x-family.html
Eval board details: https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/EVAL-AD4111.html
                    (*Refer device datasheet page for the respective EVAL boards manual)
User Guide for this code: https://wiki.analog.com/resources/tools-software/product-support-software/ad717x_ad411x_mbed_example
Communication Protocol: SPI
 
 
Hardware Setup
--------------
Required: SDP-K1 (or alternative MBED enabled controller board), EVAL-AD4111SDZ (or other AD717x/AD411x supported EVAL board), 
USB cable.
Plug in the EVAL board on SDP-K1 board (or any other Mbed enabled 
controller board) using the SDP connector and screws.
Connect SDP-K1 board to the PC using the USB cable.
 
 
How to Get Started
------------------
Open Mbed online compiler. https://ide.mbed.com/compiler
Import Code into compiler. Instructions on how to import code are here: https://os.mbed.com/docs/mbed-os/v6.8/quick-start/build-with-the-online-compiler.html
Compile code to generate binary file and then drag and drop binary into SDP-K1 controller board. Detailed instructions are here: 
https://os.mbed.com/docs/mbed-os/v6.8/build-tools/getting-your-program-on-your-board.html

Refer project wiki page to find detailed guide on how to use firmware:
https://wiki.analog.com/resources/tools-software/product-support-software/ad5592r_mbed_example
 
 
Notes
-----
Refer this page for latest documentation on Mbed-OS: https://os.mbed.com/docs/mbed-os/v6.8/introduction/index.html
A detailed user guide on SDP-K1 controller board is available here https://www.analog.com/en/design-center/evaluation-hardware-and-software/evaluation-boards-kits/SDP-K1.html.

Copyright (c) 2020 Analog Devices, Inc.  All rights reserved.