File content as of revision 13:d8f49328c57f:

#ifndef FALFALLA_H
#define FALFALLA_H

#define SWITCH_CHECK 1400
#define NUMBER_FALFALLA 2 //何号機かを入れるとそれに応じて#if以下が変わって設定が変わる

static int servo_NEUTRAL_R = 1614;
static int servo_NEUTRAL_L = 1621;
static int servo_high_FORWARD_R = 1860;
static int servo_high_FORWARD_L = 1860
static int servo_slow_FORWARD_R = 1560;
static int servo_slow_FORWARD_L = 1560;
static int turntable_NEUTRAL = 1500;//カメラ台座のサーボ
static int matchspeed = servo_NEUTRAL_R + 100; //カメラと方向を合わせるときの車輪の速度
static int minfocus = 1200;  //焦点合わせ用サーボの最小値

static float g_rightloopROLL=-17.0;
static float g_rightloopROLL_approach=-17.0;
static float g_rightloopPITCH=-6.3;
static float g_rightloopPITCH_approach = -15.0;
static float g_leftloopROLL=16.0;
static float g_leftloopROLL_approach=16.0;
static float g_leftloopPITCH=-6.0;
static float g_leftloopPITCH_approach=-13.0;
static float g_gostraightROLL=2.0;
static float g_gostraightPITCH=-3.0;
static float g_takeoffTHR=1.0;
static float g_loopTHR=0.58;

static float g_rightloopROLLshort=-20.0;
static float g_rightloopPITCHshort=-7.0;
static float g_leftloopROLLshort=22.0;
static float g_leftloopPITCHshort=-6.0;

static float g_glideloopROLL = -5.0;      //rewrite
static float g_glideloopPITCH = 0.0;
static float g_autoonPITCH = -3.0;

static int g_rightloopRUD = 1500;
static int g_rightloopRUD_approach=1500;
static int g_rightloopshortRUD = 1500;
static int g_leftloopRUD = 1500;
static int g_leftloopRUD_approach = 1710;
static int g_leftloopshortRUD = 1500;
static int g_glideloopRUD = 1500;

static int g_AIL_L_correctionrightloop = 0;
static int g_AIL_L_correctionrightloopshort = 0;
static int g_AIL_L_correctionleftloop = 0;
static int g_AIL_L_correctionleftloopshort = 0;


#if NUMBER_FALFALLA == 1    //1号機
const int8_t Reverce_falfalla[4] = {1,-1,1,1};   //Nutral:1 , Reverce:-1

#elif NUMBER_FALFALLA == 2  //2号機
const int16_t Reverce_falfalla[4] = {1,-1,1,-1};   //Nutral:1 , Reverce:-1

#endif


#endif /* ESTRELA_H_ */

/*
x軸回り    ロール
y軸回り    ピッチ
z軸回り    ヨー
*/